Before we retried immediately which caused unnecessary upload attempts and event log errors.
In the event of an "Invalid or corrupt project" error during synchronization, we now wait 30 seconds until retrying again. This time period has been lowered from 60 seconds to 30 seconds to improve recovery time. Following a project download or edit is a period in which Logical reads/writes resort to Symbolic mode, after which the driver synchronizes with the controller so Logical reads/writes can resume. Device setting, "Synchronize with Controller after", is available on the Logix Options property page. Added project change detection support for online and offline project edits. Added Device-level error message for Identity request failures. Purchasing either the Allen-Bradley ControlLogix Ethernet, Allen-Bradley DF1, Allen-Bradley DH+, Allen-Bradley Unsolicited, or Allen-Bradley PLC5/SLC505 Ethernet Driver entitles you to all of the drivers 
Note: This driver is part of our Allen-Bradley Suite.Connected Messaging for Read/Write transactions.Supports access to all pre-defined Structure Data Types (such as CAM, AXIS, and so forth).Supports device routing, which allows access to ControlLogix, PLC 5, and SLC 500 PLCs via any connecting network topology.Supports ControlLogix Gateway access via Data Highway Plus and ControlNet networks.EtherNet/IP Gateway support, which provides access to EtherNet/IP-enabled MicroLogix, SLC, and PLC 5 devices via the ControlLogix Ethernet Communications module.Serial Gateway support with unconnected messaging, which provides access to ControlLogix, CompactLogix, FlexLogix, and SoftLogix devices via the ControlLogix serial port.
Supports larger packet sizes for ControlLogix Controllers v20 and higher (configurable up to 4000 bytes) for improved performance. Supports Automatic Tag Database Generation through online Allen-Bradley Logix or file-based. Enhanced performance and reduced device loads via optimized data access calls.
0 kommentar(er)
